If your AquaDam® has a small hole in it, it can be mended by using patch tape. If the hole is irreparable and your AquaDam® is located in moving water, then you must drain your AquaDam® and re-line it on shore. However, if your AquaDam® is in a non-moving body of water, it can be re-lined in place by following the procedure outlined on the next pages.

If the AquaDam® has been moved out of position or is twisted, water must be pumped out of the AquaDam® until it is buoyant. Maneuver the dam until it is back in its original position. This can be done by pulling the AquaDam® manually, or, in this case, pumping water into the work area until the AquaDam® is forced out by the water pressure.

Once the AquaDam® is back in position, re-lining can take place.

Every large AquaDam® has string lines running through the inner tubes specifically so that they can be re-lined. These string lines are thin and are not for pulling the new liner through. They are simply to pull another, stronger, rope through the inner tube.